top of page

FAQ
- 01
- 02The material is completely sealed and has no porosity at all. (This is also what makes it resistant to moisture and hand sweat.) However, without porosity, traditional hide glue cannot penetrate the material properly and the bond is not ideal. It is therefore essential to use the natural bone glue we supply with our fingerboards. This glue has existed for centuries and is used in many crafts.
- 03Our range is designed to answer the situations luthiers most often meet. The "Final" series has the finished dimensions and should be used when the neck is very straight and little or no material needs to be removed during fitting. If the neck is slightly warped, or its surface is not perfectly flat, we recommend the "Large" series: it has exactly the same top surface, but with a little extra material on the sides and under the sole, allowing more adjustment. If the fingerboard needs to be reworked even more deeply, the "Raw" series has additional extra material, for even more room to adjust.
- 04The "Extra Light" is the lightest fingerboard in our range. It is designed to match the finished dimensions with the lowest possible weight. The weight saving comes from partly hollowing the inside of the fingerboard, within the glue channels. At least 2 mm of material remains under the fingerboard. This allows light planing, which will most likely not be needed, since surface wear is almost nil. If you want more material to plane, we recommend the "Final Standard" or even the "Large Standard".
- 05We have long experience of how our fingerboards wear, and we pay close attention to this aspect of their quality. Since each fingerboard is played with a different frequency and duration, no general rule can be given. However, our experience shows that a fingerboard played four hours a day by a top-level musician shows no noticeable wear after five or six years.
- 06Yes. We built our range to meet the needs of as many luthiers as possible, but every instrument is unique, and some situations call for something different. We are happy to make custom fingerboards, and we consider every request. Since every fingerboard is machined in our own workshop, we can often adapt the dimensions, profile or weight to your instrument. Tell us about your instrument and what you need, and we will get back to you with a price and lead time.
- 07They arrive packed in a protective, recyclable PE plastic bag, with surfaces polished to a satin, mirror-like finish. Corène fingerboards need no maintenance to keep their properties over time. If you wish, you can enhance the shine with a tiny drop of oil, but really very little: the fingerboard is completely sealed and absorbs nothing at all.
- 08
- 09Every variant can be made for all the instruments in our range, but only the best-selling models are always kept in stock. In our range tree, they are shown in blue. Models shown in green are made on demand: you can order them from our shop, following the usual checkout steps. Just allow 2 to 3 weeks for manufacturing before your fingerboard is shipped. For models not listed in our shop, or for a fully custom fingerboard, simply contact us.
- 10There are two options. The first is to place a pre-order: as soon as the product is back in stock, it will be shipped to you with priority. However, the number of pre-orders is limited, and your pre-order may be declined if demand is too high. The second is to ask to receive an email as soon as the product is back in stock.
Contact Us
Have questions?
Complete our contact form:
bottom of page
